Owner's Manual

6
To make assembly easier, carefully read the
following assembly tips:
• Assembly requires two persons.
• Because of its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you complete all assembly steps.
• For help identifying small parts, see page 5.
• The included grease and the following tools (not
included) may be required for assembly:
Two adjustable wrenches
One hammer
One standard screwdriver
One Phillips screwdriver
Assembly may be easier if you have your own
set of wrenches.
ASSEMBLY
2
1
17
17
37
Indents
13
8
3
Warning
Decals
18
18
16
17
1
1
1. Orient the Crossbar (3) so that the warning
decals are on top.
Attach the Crossbar (3) to one of the Uprights
(1) with two M8 x 55mm Bolts (18), two M8
Washers (16), and two M8 Locknuts (17); do
not tighten the Locknuts yet.
Attach the Crossbar (3) to the other Upright
(1) in the same way.
2. Orient the Stabilizer (13) so that the indented
holes are facing the floor.
Attach the Stabilizer (13) to the Front Leg (8)
with two M8 x 42mm Carriage Bolts (37) and
two M8 Locknuts (17); do not tighten the
Locknuts yet.