Owner's Manual

8
7. Orient the Backrest Tubes (5) and the Backrest
(6) as shown.
A
ttach the Backrest Tubes (5) to the Backrest
(6) with four M6 x 38mm Screws (30) and four
M
6 Washers (26); do not tighten the Screws
yet.
8. Insert the Backrest Support (7) into a set of
holes in the Uprights (1). Rotate the Backrest
Support to the locked position, with the locking
pin wrapped around the left Upright.
Apply grease to an M10 x 137mm Bolt (36).
Attach the Backrest Tubes (5) to the welded
tube on the Frame (2) with the M10 x 137mm
Bolt (36), two M10 Washers (34), and an M10
Locknut (33). Do not overtighten the Locknut;
the Backrest Tubes must pivot easily.
See steps 1–4. Tighten the M8 Locknuts (17).
See step 7. Tighten the M6 x 38mm Screws
(30).
9. Attach the Seat (11) to the Frame (2) with four
M6 x 16mm Screws (29).
7
5
30
26
26
Holes
30
6
8
Grease
34
5
36
7
1
2
Welded
Tube
1
Locking
Pin
33
34
9
11
29
2
10. Slide a Weight Stop (28) onto the weight tube
on a Fly Arm (25).
Slide a Weight Stop (not shown) onto the
other Fly Arm (not shown) in the same way.
10
28
Weight
Tube
25