Owner's Manual

9
11. Attach a Fly Arm (25) to an Upright (1) with an
M10 x 120mm Bolt (19) and an M10 Locknut
(33). Make sure that the Fly Arm is resting
a
gainst the outer side of the Fly Arm Stop
(15). Do not overtighten the Locknut; the Fly
A
rm must pivot easily.
Attach the other Fly Arm (25) in the same
way.
12. Insert a Short Pad Tube (12) into one of the Fly
Arms (25) from the side shown. Next, slide a
Foam Pad (23) onto the Short Pad Tube.
Repeat this step on the other side of the
weight bench.
13. Attach the Curl Pad (43) to the Curl Post (27)
with two M6 x 16mm Screws (29).
14. Make sure that all parts are properly tightened before the weight bench is used. Note: Some hardware
may be left over after assembly is completed. The use of all remaining parts will be explained in ADJUST-
MENT, beginning on page 10.
33
25
15
25
19
1
11
13
23
43
27
29
12
25
12