Owner's Manual

17. Slide the end of the High Cable (13) onto the M10 x

20mm Bolt (26) in the Weight Carriage (22). Tighten

an M10 Nylon Locknut (11) onto the Bolt.

18. Wrap the High Cable (13) around a Pulley (5) as

shown. Hold a Cable Trap (21) against the Pulley

and attach a Pulley Plate (19) to each side of the

Pulley using an M10 x 45mm Bolt (40) and an M10

Nylon Locknut (11). Make sure the Cable Trap

holds the High Cable in the groove of the Pulley.

Do not overtighten the Nylon Locknut; the

Pulley must be able to turn freely.

19. Wrap the indicated end of the Low Cable (8) around

a Pulley (5). Attach the Pulley to the bracket on the

Base Crossbar (20) using an M10 x 45mm Bolt (40)

and an M10 Nylon Locknut (11). Do not overtight-

en the Nylon Locknut; the Pulley must be able

to turn freely.

20. Wrap the Low Cable (8) around a Pulley (5) as

shown. Hold a Cable Trap (21) against the Pulley

and attach the Pulley and Cable Trap to the lowest

set of holes in the two Pulley Plates (19) using an

M10 x 45mm Bolt (40) and an M10 Nylon Locknut

(11). Make sure the Cable Trap holds the Low

Cable in the groove of the Pulley. Do not over-

tighten the Nylon Locknut; the Pulley must be

able to turn freely.