Owner's Manual

13
16
13
14
ATTACHING WEIGHTS TO THE BARBELL OR THE
WEIGHT CARRIAGE
To use the Barbell (35), slide the desired amount of
weight (not included) onto each end of the Barbell.
Secure the weights with Weight Clips (51).
Weights can be attached to the weight tube on the
Weight Carriage (22) in the same manner.
ATTACHING THE LAT BAR TO THE HIGH PULLEY
STATION OR THE LOW PULLEY STATION
To use the high pulley station or the low pulley station,
attach the Lat Bar (16) to the High Cable (13) or the
Low Cable (not shown) using a Cable Clip (14).
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight
rack, can stretch slightly when it is first used. If the
cables need to be tightened, remove the M10 Nylon
Locknut (11) and the M10 x 45mm Bolt (40) from the
lower end of the Pulley Plates (19). Reattach the Pulley
(5) and Cable Trap (21) to the next higher set of holes
in the Pulley Plates. Make sure the Cable Trap holds
the Low Cable (8) in the groove of the Pulley. Repeat
until the cables are properly tightened. Do not over-
tighten the Nylon Locknut; the Pulley must be able
to turn freely.
51
22
35
Weights
WARNING:Do not place more than
300 pounds on the Barbell (35). Do not place
more than 150 pounds on the Weight Carriage
(22). Always place the same amount of weight on
each side of the Barbell or the Weight Carriage.
Always secure weights with Weight Clips (51).
19
40
21
8
5
11
WARNING:Always remove the Lat
Bar (16) when performing an exercise that does
not require the use of the Lat Bar.