Owner's Manual

3. Attach an Upright (1) to a Base (7) using two Joint
Plates (12), four M10 x 80mm Bolts (41), and four
M10 Nylon Locknuts (11). Make sure the Uprights
are oriented exactly as shown. Do not tighten the
Nylon Locknuts yet.
Repeat this step with the other Upright (1).
3
1
1
41
12
12
7
7
12
12
11
41
6
4. Insert a Weight Guide (18) into the indicated hole in
each Base (7). Attach the Weight Guides to the
Bases using two M10 x 75mm Bolts (39), four M10
Small Washers (6), and two M10 Nylon Locknuts
(11). Do not tighten the Nylon Locknuts yet.
5. Press a 25mm Bushing (48) into each end of the
Locking Bar (34). Slide the Barbell (35) through the
Locking Bar.
4
18
18
39
39
6
11
7
7
11
6
6
6
5
34
35
48
48