Owner's Manual

14
16. Orient a Press Arm Handle (17) with the 90° bend
at the top as shown in the inset drawing. Attach a
Press Arm Handle (17) to the Right Press Arm
(
16) with two M10 x 65mm Button Bolts (106),
four M10 Washers (80), four 11mm Spacers (99),
a
nd two M10 Locknuts (77).
Repeat this step for the Left Press Arm (not
shown).
17. Attach the Left Press Arm (15) to the Right Press
Arm (16) with an M10 x 110mm Bolt (93), an
89.5mm Spacer (59) and an M10 Locknut (77).
Finish attaching the Press Arms with two M10 x
65mm Bolts (85), two M10 Washers (80), and two
M10 Locknuts (77). Do not tighten the
Locknuts yet.
18. Attach the Left and Right Press Arms (15, 16) to
the Base (1) with an M10 x 110mm Bolt (93), an
89.5mm Spacer (59), and an M10 Locknut (77).
Do not over tighten the Locknut; the Press
Arms (15, 16) must be able to pivot freely.
See step 17. Tighten the Locknuts (77).
17
16
15
77
77
59
93
80
85
18
16
15
77
1
106
16
9
9
99
99
80
80
77
99
80
80
17
1
6
90° Bend
90°
Bend
Grease
59
93