User's Manual

22, Refer to the CABLE DmAGRAMS on pages 27
and 28 as you assemble the cables and to
identify the cables.
Locate the Lat Cable (71). Route the CaMe up
through the Right Top Frame (7) and over a
90mm Pulley (39). Make sure the Cable is
between the Pulley and the rod in the Top
Frame. Attach the Pulley inside the Top Frame
with an MIO x 80mm Bolt (111), two MIO
Washers (116), two 19mm Spacers (77), and an
MIO Nylon Locknut (114),
23, Route the Lat Cable (71) over a 90mm Pulley
(39) and down through the Right Top Frame (7),
Make sure the Cable is between the Pulley
and the rod in the Top Frame. Attach the Pulley
inside the Top Frame with an MIO x 80mm BoUt
(111), two MIO Washers (116), two 19mm
Spacers (77), and an MIO NyUon Locknut (114).
24, Wrap the Lat Cable (71) under a 90mm Pulley
(39), Attach the Pulley, a Small Cable Trap (48),
and two Half Finger Guards (42) at the second
hole from the top of the two Pulley Hates (51)
with an MIO x 52mm Bolt (102) and an MIO
Nylon Locknut (114), Make sure the Cable Trap
and Finger Guards are oriented as shown.
25, Route the Lat CaMe (71) up through the Right
Top Frame (7) and over a 90mm Pulley (39),
Make sure the Cable is between the Pulley
and the rod in the Top Frame. Attach the Pulley
inside the Top Frame with an MIO x 80mm BoUt
(111), two MIO Washers (116), two 19mm
Spacers (77), and an MIO Nylon Locknut (114),
26, Wrap the Lat Cable (71) around a 115mm Pulley
(41), Attach the Pulley and a Large Cable Trap
(125) to the Right Top Frame (7) with an MIO x
110mm Bolt (73) and an MIO Nylon Locknut
(114),
22
23
25
71
39
116
71
111
11
114
_114
39
114
39
42
102
71
7
6
114
73
125
13