User's Manual

27, Route the Lat Cable (71) over a 90mm Pulley
(39) and down through the Left Top Frame (8),
Attach the Pulley inside the Top Frame with an
MIO x 80mm Bolt (111), two MIO Washers (116),
two 19mm Spacers (77), and an MIO Nylon
Locknut (114),
28, Wrap the Lat Cable (71) under a 90mm Pulley
(39), Attach the Pulley, a Small Cable Trap (48),
and two Full Finger Guards (43) to the Dip Assist
(21) with an MIO x 232mm Bolt (108), three MIO
Washers (116), two 40mm Spacers (74), and an
MIO Nylon Locknut (114), Make sure the Cable
Trap is oriented as shown.
29, Attach the Lat Cable (71) to the bracket on the
Rear Upright (6) with an M8 x 22mm Shoulder
Bolt (88) and an M8 Nylon Locknut (115), Make
sure the fiat edge of the Cable is against the
bracket.
30, Locate the Ab CabJe (72}. Wrap the Cable over
a 90mm Pulley (39), Attach the Pulley and the
two Quarter Guards (95) to the Right Upright (4)
with an MIO x 108mm Bolt (99), an MIO Washer
(116), and an MIO Nylon Locknut (114), Make
sure that the rod is inserted through both
Quarter Guards and is over the Carte.
31, Wrap the Ab Cable (72) under a 90mm Pulley
(39), Attach the Pulley and two Half Finger
Guards (42) to the Double "U"obracket (52) with
an MIO x 48mm Bolt (101) and an MIO Nylon
Locknut (114), Make sure the Finger Guards
are oriented as shown.
27
29
3O
31
39 111
\\\\ _,,
74
115
6
/
/
/
Fiat
Edge
72
42
14