User's Manual

Make sure aH parts are properUy tightened each time the weight system is used, RepUace any worn parts imme°

diateUy,The weight system can be cUeaned with a damp cloth and a mild, non-abrasive detergent, Do not use

soUvents,

TIGHTENING THE CABLES

Woven came, the type of came used on the weight system, can stretch slightly when it is first used, Ufthere is

sUackin the caMes before resistance is feUt,the caMes shouUd be tightened, To tighten the caMes, first insert the

weight pin into the middUe of the weight stack, SUackcan be removed from these caMes severaU ways:

See drawing 1. Tighten the M8 Nylon Locknut

(115) that connects the end of a came to a "U'=

bracket (50),

See drawing !. Remove the MIO Nylon Locknut

(114) and the MIO x 52mm BoUt(102) from the

Small CaMe Trap (48), 90mm Pulley (39), the two

Haft Finger Guards (42), and a "U'°bracket (50),

Reattach the Pulley, Cable Trap, and Finger

Guards to the other hole in the "U'°bracket, Make

sure that the CaMe Trap and Finger Guards are

oriented as shown and that the cable and

Pulley move smootHy.

See drawing 2. Remove the MIO Nylon Locknut

(114) and the MIO x 52mm Bolt (102) from the

Small Cable Trap (48), the 90mm Pulley (39), the

two Half Finger Guards (42), and the two Pulley

Hates (51), Reattach the Pulley, Cable Trap, and

Finger Guards to the next closer hole to the center

of the Pulley Hates, Make sure that the Cable

Trap is oriented to hold the cable in the groove

of the Pulley, that the Finger Guards are orient-

ed as shown, and that the CaMe and Puttey

move smoothly.

See drawing 3. Loosen the M12 Nut (128) on a

cable, Tighten the cable into the Weight Tube (not

shown) until the slack is removed from the cables,

Retighten the M12 Nut against the M12 Washer

(129),

iITi

Do not overtighten the cables, if the cabJes are overtightened, the top weight wilt be Hfted off the weight

stack. If a cable tends to slip off the pulleys often, it may have become twisted. Remove the cable and

re-install it. If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of

this manual,