Owner's Manual

10
7. Apply some of the included grease to an M10 x
57mm Bolt Set (80).
Orient the Leg Lever (13) so that the high end of
the bracket is in the location shown.
Attach the Leg Lever (13) to the Leg (10) with
the M10 x 57mm Bolt Set (80). Make sure that
t
he barrel of the Bolt Set is inserted through
both sides of the bracket on the Leg.
7
80
13
80
10
Grease
High
End
8
8. See the CABLE DIAGRAM on page 38 to
identify the cables as you assemble them.
Identify the Burn Cable (45).
Identify the four Burn Pulleys (68), the three
V-pulleys (not shown), and the twenty
Pulleys (not shown).
Route the threaded end of the Burn Cable (45)
through the bracket on the Base (1) as shown.
Attach a Burn Pulley (68) over the Burn Cable
(45) inside the bracket on the Base (1) with an
M10 x 63mm Bolt (89), two 12.7mm Spacers
(73), and an M10 Locknut (74).
89
73
73
74
Threaded
End
1
68
45
9. Attach a second Burn Pulley (68) over the Burn
Cable (45) inside the bracket on the Base (1)
with an M10 x 63mm Bolt (89), two 12.7mm
Spacers (73), and an M10 Locknut (74).
9
89
73
73
74
1
68
45