Owner's Manual

23
39. Route the Low Cable (43) under a Pulley (69).
Attach the Pulley (69) and a Cable Trap (71) to
t
he center bracket on the Base (1) with an M10
x 50mm Button Bolt (76), two Half Guards (72),
a
nd an M10 Locknut (74).
Make sure that the Cable Trap (71) is ori-
ented to hold the Low Cable (43) in the
groove of the Pulley (69). Make sure that the
Half Guards (72) are outside the bracket.
39
69
4
3
72
74
76
72
1
40. Route the Low Cable (43) over a Pulley (69).
Using the last hole in the Pulley Plates (70),
attach the Pulley Plates to the Pulley (69) with
an M10 x 43mm Bolt (65) and an M10 Locknut
(74).
40
74
70
65
69
43
41
41. Route the Low Cable (43) under a Pulley (69).
Attach the Pulley (69) and a Cable Trap (71) to
the rear bracket on the Base (1) with an M10 x
50mm Button Bolt (76), two Half Guards (72),
and an M10 Locknut (74).
Make sure that the Cable Trap (71) is ori-
ented to hold the Low Cable (43) in the
groove of the Pulley (69). Make sure that the
Half Guards (72) are outside the bracket.
69
71
43
72
74
76
72
1
71