User manual

Changingregistrationdata,settinguppasswordprotection
▶ Enter the user name and password.
▶ To change the registration data, enter the new user name
and the new password twice, then click on Change
registration.
▶ To deactivate password protection, do not enter any new
data, but instead click on No registration data.
▶ If you have changed the registration data, you must log
back in again afterwards.
A forgotten password can be overwritten if the
coupler gets restarted with no modules con-
nected.
The status data can be displayed at all time,
regardless of the state of the eld bus connec-
tion. Setup changes can only be stored while
the eld bus is not active.
After registration, the connected station is displayed with all
of its active modules.
Exampledisplayaftertheprogramstartsup
The web server only registers modules that
can communicate on the system bus. Empty
slot modules and other passive modules (e.g.
AUX modules) are not registered by the web
server and thus are not displayed in the screen
view. The numbering of the modules in the
web server view may therefore deviate from
the count in the actual station!
10.5 Navigationandoperatinginstructions
Settingthelanguage
When the program is started, the web server attempts to
start with the PC's language settings. If this language is not
supported by the web server, the program starts with the
“English” setting.
New language versions are continually being developed and
can be later installed by the user with separate language
les.
▶ To change the language, click on Language and choose
the desired setting.
Settingthelanguage
Zoomingtheviewin/out
▶ Click on the magnifying glass symbol to zoom in or out
on the station's display.
Scalingthedisplay
Web server | Navigation and operating instructions
264 1432790000/03/02.2014Manual u-remote