User manual

Detailed descriptions of I/O modules | Digital counter module UR20-1CNT-100-1DO
146 1432790000/03/02.2014Manual u-remote
Parameter: counting direction Inverted / non-inverted 1 0
-never
Bit 0
UR20-1CNT-100 DO - Counter operation through parameter\signal evaluation\pulse/direction (A/B)
Filter *
Filter *
Filter *
Filter *
Filter *
CH0ACH0BOutResetLatchGate
Parameter:
counter function continuous = open
Parameter:
I/O image: setting value integer 32
end value integer 32
Parameter: cancel/interrupt internal gate counter function
Parameter:
reset -never -high level -rising edge -1-time rising edge
&
Parameter: function output never ≤ comparison value ≥ comparison value = comparison value
=
=
≧
I/O image: Comparison value integer 32
Bus
24 V
Counter
Latch
Alarms
Parameter pulse duration
Control word „Activate reset mode“
Control word „Release DO“
Control word „Set SW gate“
Parameter: HW gate deactivated: SW gate only activated: SW gate and HW gate with 24 V
Control word „Load setting value“
Counting value Latch Status word Time stamp Alarm for diagnostic messages
Parameter: load value integer 32