User manual
▶ Lift the electronic unit removal lever and swivel it for-
wards by 90°.
1.
2.
Unlockingtheelectronicunit
Openingtheremovalleverfortheelectronicunit
▶ Using the removal lever, pull the electronic unit forwards
and out.
Pullingouttheelectronicunit
▶ If the existing electronic unit was coded, insert the new
coding pins into the coding seats located in the base
module (see Section 7.4).
▶ Hold the new electronic unit by the top and the bottom,
and carefully slide it into the base module.
The electronic units are functionally coded
so that they can only be inserted into the ap-
propriate base module. If it is not possible to
insert a new electronic unit into the base mod-
ule, check if the combination is correct and if
there is a possible mix-up.
Replacingcomponents | Replacing the electronic unit
275Manual u-remote1432790000/03/02.2014