User manual

Web server | Web server in Force mode
268 1432790000/03/02.2014Manual u-remote
Display of process data
▶ To leave this view, click on Close.
Displayingdiagnosticdata
▶ Click on Station data and then on Diagnostic data.
In the overview, all of the modules are displayed with sym-
bols; if there is a green dot next to a module, there are no
messages. Modules that have a red dot next to them have
adiagnostic message.
Displayofdiagnosticdata
▶ To view a diagnostic message, click on the red dot.
▶ To leave this view, click on Close.
10.9 Web server in Force mode
WARNING!
Manipulation of the control unit!
In Force mode, the system may be manipu-
lated to such an extent that can result in life-
threatening personal injury and damage to
materials.
Only use Force if you are very familiar with
the connected system and know at all times
the consequences that your actions will have!
If the force mode is activated during an estab-
lished eld bus connection a diagnose alarm is
generated. Depending on parametrized alarm
behaviour the PLC can continue to transmit
process data and the u-remote station will pro-
cess them for all unforced channels. However,
forced channels will ignore any process data
and behave according to forced values.
This function allows you to carry out functional tests or pre-
congure the station prior to commissioning, even if sensors
have not yet been connected.
To do so, you must change the operating mode of the web
server.
▶ Click on Force and Activate.
SwitchingovertoForcemode
The web server is now in Force mode.
When Force mode is activated, the screen dis-
play changes – the entire station is highlighted
and outlined in warning colours.