User manual
11.4 Removing/replacingconnectors
WARNING
Explosion risk!
▶ Prior to starting work, make sure that
there is not a potentially explosive atmos-
phere!
WARNING
Operation of the machine/system can
be disrupted!
▶ In the event of the machine/system being
put into a dangerous state as a result of
the removal of a connector, a replacement
can only be made once the machine/sys-
tem is disconnected from thepower!
WARNING
Risk of contact re!
▶ Remove connectors only while they are
load current free.
ATTENTION
The product can be destroyed by elec-
trostatic discharge!
The components in the u-remote series can
be destroyed by electrostatic discharge.
▶ Please make sure that personnel and work
equipment are adequately earthed!
▶ Open the connector frame and flip it open so far that you
can reach the connector.
Unlockingtheconnectorframe
▶ Press both sides of the connector together so that it can
be slid off the frame.
Pushingtheconnectortogether
▶ Remove the connector by pulling it off.
▶ Insert the new connector in the frame so that it audibly
clicks into place.
▶ Close the connector frame.
Replacingcomponents| Removing/replacing connectors
278 1432790000/03/02.2014Manual u-remote