User manual

Detailed descriptions of I/O modules | Digital counter module UR20-2CNT-100
160 1432790000/03/02.2014Manual u-remote
CH0 ACH1ACH1B CH0B
Parameter: cancel/interrupt internal gate 0 counter function
I/O image setting value K1 integer 32
Parameter:
end value K1 integer 32
Parameter:
comparison value <= comparison value >= comparison value =
Parameter: comparison value <= comparison value >= comparison value =
Parameter: counter function K0 continuous = open
Parameter:
load value K1 integer 32
SW gate set CCTRL II bit 2
CCTRL II
Bit 1 set Bit 9 reset
CCTRL I
bit 1 set bit 9 reset
SW gate reset CCTRL II bit 10
Load setting value CCTRL II bit 5
Reset: flags overrun, underrun, comparison, end value, CCTRL II bit 6
SW gate set CCTRL I bit 2
SW gate reset CCTRL I bit 10
I/O image
setting value K0
integer 32
Parameter: load value K2 integer 32
Parameter: load value K0 integer 32
Load setting value CCTRL I bit 5
Reset: flags overrun, underrun, comparison, end value, CCTRL II bit 6
Alarms
Filter *Filter *Filter *Filter *
Counting value 1/2 Status word 1/2 Time stamp Alarm for diagnostic messages
Set comparison bit parameter K1
Set comparison bit parameter K0
2CNT100 – counter operation through parameter\signal evaluation\rotary transducer xxx
Bus
24V
Parameter:
counter function K1 continuous = open
Parameter:
counter function internal gate 1 cancel/interrupt
==
>1
=
>1
=
Counter Counter