User manual

ActivatingtheEthernetsocket
▶ Enter the required IP address and subnet mask.
▶ Confirm the entry by clicking OK.
▶ Close the coupler window and restart the coupler.
You can review the IP address in the Network and Sharing
Center, which is found in the Windows Control Panel:
▶ Under Unidentified network, click on LAN connec-
tion.
The LAN connection status window opens.
LAN connection status
▶ Click on Details.
The Network connection details window opens.
Network connection details
The IP address of the virtual LAN port (the USB connection)
is displayed under IPv4 DHCP server. The standard IP ad-
dress is: 192.168.1.202.
The web server is started.
10.4 Settingupregistrationdataandpassword
protection
If you do not set up any users, all web server functions are
accessible to every user at all times!
As soon as you set up one user with password protection,
users without a user ID will only have read-only rights. Write
access is blocked for them, which means that they cannot
do the following:
– Change parameters
– Operate the station in Force mode
– Load firmware updates
When you start up the web server for the rst time, you are
prompted to enter the registration data. The Change regis-
tration data window opens automatically. You can access
this window later via the Coupler status dialogue box (see
Section 11.4):
Web server | Setting up registration data and password protection
263Manual u-remote1432790000/03/02.2014