User Documentation
148
Devices – Energy Analyser 550
2008050000/03/02-2018
INFOBEREICH
Die Angabe „MatNr/Version/Datum“ bzw. „1234560000/00/MM.YY“ ist als Textvariable deniert
und kann nur auf der „Rueckseite“ editiert werden. Die Textvariable erscheint in allen Doku-
menten dieses Buches, sobald eine Synchronisierung des gesamten Buches(!) durchgeführt
wird. ACHTUNG Die „Rueckseite” muss als Formatquelle(!) ausgewählt sein!
• DHCP mode
When started, the Energy Analyser 550 obtains all its settings from the DHCP server.
IMPORTANT: Setting should only be undertaken after these have been discussed with the administrator.
4.4.3.24 Naming of inputs
• Enables naming of inputs and outputs.
• The respective inputs/outputs can be assigned names by entering a name in the corresponding box.
4.4.4 Interfaces
4.4.4.1 Modbus
Modbus address list
A list of the measurement values available in the devie with the corresponding addresses and formats can be
found on the CD/DVD provided with ecoExplorer go.
Further information at:
Energy Analyser D550 - Modbus
Energy Analyser 550 – Ethernet
Ethernet: Introduction
To be able to operate the Energy Analyser 550 in the Ethernet, the Energy Analyser 550 requires an Ethernet
address. There are three options here:
• Fixed IP address
• In networks without a DHCP server, the network address must be set directly in the Energy Analyser 550.
• BootP
• BootP allows for the fully automatic integration of a Energy Analyser 550 into an existing network.
• However, BootP is an older protocol and does not provide the scope of functions provided by DHCP.
• DHCP mode
• DHCP allows for the fully automatic integration of a
• EnergyAnalyser550intoanexistingnetworkwithoutadditionalconguration.
• When started, the Energy Analyser 550 automatically draws the IP address, the network screen and the
gateway from the DHCP server.
• For more information, refer to the Energy Analyser 550 guide!
Ethernet: Fixed IP address
In networks without a DHCP server, the network address must be set directly in the Energy Analyser 550. To
do this, the following settings must be carried out:
1.SetuptheEnergyAnalyser550foraxedIPaddress.