Approval/Certificate/Document of Conformity

NF X 70100-1: 2006 & NF X 70-100-2: 2006
Conclusion
When tested in accordance with the procedure specified in NF X 70100-1:
2006 & NF X 70-100-2: 2006 at a temperature of 600°C, the results obtained
were
C.I.T calculated in accordance with NF F 16-101 (withdrawn) = 4.24
R value calculated in accordance with BS 6853 Annex B.1(withdrawn) /
LUL S1085 Attachment A.1 = 0.32
It must be noted that the following applies to BS 6853 (withdrawn):
this R value must only be used to demonstrate compliance against
th
e requirements specified in Tables 7 & 8 (minor use materials),
Table 11 (textiles) and Tables 13 & 14 (cables) of BS 6853: 1999
(withdrawn)
. Should an R value be required to demonstrate
compliance against any other table in BS 6853: 1999 (withdrawn),
then a test in accordance with BS 6853: 1999: Annex B.2
(withdrawn) must be performed.
C.I.T
NLP
calculated in accordance with BS EN 45545-2:2013+A1:2015 =
0.06
It must be noted that this C.I.T value must only be used to demonstrate
compliance of non-listed
products. Should a C.I.T value be required to
demonstrate compliance of a general product or cable product, then a CIT
G
or C.I.T
C
must be calculated.
Validity
The specification and interpretation of fire test methods are the subject of
ongoing
development and refinement. Changes in associated legislation may
also occur. For these reasons it is recommended that the relevance of test
reports over five years old should be considered by the user. The laboratory that
issued the report will be able to
offer, on behalf of the legal owner, a review of
the procedures adopted for a particular test to ensure that they are consistent
with current practices, and if required may endorse the test report.
This report may only be reproduced in full. Extracts or abridgements shall not be
published without permission of Exova Warringtonfire.
Document No.: Additional Test Report
386712
Page No.: 8 of 11
Author: T. Mort Issue Date: 28
th
July 2017
Client: Weidmüller Interface
GmbH & Co. KG
Issue No.: 1