Approval/Certificate/Document of Conformity

BS EN 45545-2:2013+A1:2015
Test Results
Applicability of test
results
The test results relate only to the behaviour of the specimens of the product under
the particular conditions of test; they are not intended to the sole criterion for
assessing the potential smoke hazard of the product in use.
The test results relate only to the specimens of the product in the form in which
they were tested. Small differences in the composition or thickness of the product
may significantly affect the performance during the test and will therefore
invalidate the test results. It is the responsibility of the supplier of the product to
ensure that the product which is supplied is identical with the specimens which
were tested.
Smoke Density
Test method referenced “T10.03” requires the Ds(max) to be calculated. That is
the maximum specific optical density within the first 10 minutes test duration.
Specimen 1
Specimen 2
Specimen 3
Mean Average
Ds(max) within
10 minutes
101 92 83 92
Additional Test
Data
Additional smoke density data along with observations obtained throughout the
duration of the test is tabulated in Appendix I of this test report.
A graph of the results obtained is illustrated in Appendix II of this test report.
Summary of results
The average Ds(max) value determined within 10 minutes was 92
Document No.: Additional Test Report
386710
Page No.: 6 of 10
Author: T. Mort Issue Date: 28
th
July 2017
Client: Weidmüller Interface
GmbH & Co. KG
Issue No.: 1