Document of Conformity

ManualsBrandsWeidmueller ManualsAutomation & SoftwareIE-MC-VL-1TX-1SC

[13]

Schedule

[14]

TYPE EXAMINATION CERTIFICATE No.

DEMKO 11 ATEX 1106692X

Rev. 2

00-IC-F0060-1 – Issue 13.2

This certificate may only be reproduced in its entirety and without any change, schedule included.

Page 2 of 2

[15] Description of Product:

The subject models are DIN rail mounted industrial application ethernet communication devices. They are intended for Industrial

Applications, pollution degree 2 environments. They are microcomputer-based and communicate via interfaces through wire. Subject

models are of the open type and are intended for installation into a suitable enclosure.

Industrial Media Converter Series IE-MC, followed by –VL or –VLT, followed by -1TX, followed by –1SC or –1ST, followed by (S) or blank.

Model Differences:

Model No. of Ethernet RJ45 Ports No. of Fiber Port (M.M.) No. of Fiber Port (S.M.)

IE-MC-VL-1TX-1SC 1 1 -

IE-MC-VLT-1TX-1SC 1 1 -

IE-MC-VL-1TX-1ST 1 1 -

IE-MC-VLT-1TX-1ST 1 1 -

IE-MC-VL-1TX-1SCS 1 - 1

IE-MC-VLT-1TX-1SCS 1 - 1

Note :

S.M. – Single-mode Fiber

M.M. – Multi-mode Fiber

SC – SC Fiber connector

ST – ST Fiber connector

Performance testing

The optical radiation output of the productwith respect to explosion protection, according to Annex II clause 1.3.1 of the Directive

2014/34/EU is not covered in this certificate.

Temperature range:

The relation between ambient temperature and the assigned temperature class is as follows:

Ambient temperature range Temperature class

-40

C to +75

C for suffix with –VLT

0 °C to +60 °C for suffix with –VL

Electrical data:

Model Electrical Rating Relay Output Protection Method

Series IE-MC 12-48VDC, 0.7A Max. 24VDC, 1A, Resistive nA nC

Routine tests:

No routine tests are necessary.

[16] Descriptive Documents

The scheduled drawings are listed in the report no. provided under item no. [ 8 ] on page 1 of this Type Examination Certificate.

[17] Special Conditions of Use:

• The Ethernet Communication Devices are intended for mounting in an ATEX-Certified tool-accessible IP54 enclosure and used in

an area of not more than pollution degree 2 as defined by EN 60664-1.

• Provisions shall be made, either in the equipment or external to the equipment, to provide the transient protection device to be

set at a level not exceeding 140% of the peak rated voltage.

[18] Essential Health and Safety Requirements

The Essential Health and Safety Requirements (EHSRs) covered by the standards listed at item 9.

Additional information

The trademark will be used as the company identifier on the marking label.