Document of Conformity

[13] Schedule

[14] TYPE EXAMINATION CERTIFICATE No.

DEMKO 11 ATEX 150190X Rev. 3

00-IC-F0060-1 – Issue 13.2 This certificate may only be reproduced in its entirety and without any change, schedule included. Page 2 of 2

[15] Description of Product:

The devices are DIN rail mounted industrial Ethernet switches and media converters. Models covered by this certificate are: Models IE-SW-

PL10M-3GT-7TX, IE-SW-PL10MT-3GT-7TX, IE-SW-PL10M-1GT-2GS-7TX and IE-SW-PL10MT-1GT-2GS-7TX.

Model Differences – As outlined below:

Models

RJ 45 Port

Fiber Ethernet Port

IE-SW-PL10M(T)-3GT-7TX

7 x 10/100Base T(X) ports and 3 x 1000BaseT(X) ports

IE-SW-PL10M(T)-1GT-2GS-7TX

7 x 10/100Base T(X) ports and 1 x 1000BaseT(X) ports

2 x SFP fiber connectors

(T) in Model names does not affect electrical properties of the models

The optical radiation output of the product with respect to explosion protection, according to Annex II clause 1.3.1 of the Directive

2014/34/EU is not covered in this certificate.

Temperature range:

The relation between ambient temperature and the assigned temperature class is as follows:

Ambient temperature range Temperature class

-40 °C to +75 °C T4

Electrical data

Rated Supply Voltage and Current

12 - 45 V dc, Maximum 1.46 A, Class 2

Relay Output

24 V dc, 1 A

Routine tests:

N/A

[16] Descriptive Documents

The scheduled drawings are listed in the report no. provided under item no. [ 8 ] on page 1 of this Type Examination Certificate.

[17] Special Conditions of Use:

 These products are intended to be mounted in an ATEX-Certified IP54 enclosure accessible only with use of a tool, and the device

must be used in an area of not more than pollution degree 2 as defined in EN 60664-1.

 Provisions shall be made to provide the transient protection device to be set at a level not exceeding 140% of the peak rated voltage.

[18] Essential Health and Safety Requirements

The Essential Health and Safety Requirements (EHSRs) covered by the standards listed at item 9.

Additional information

The trademark will be used as the company identifier on the marking label.