Approval/Certificate/Document of Conformity

00-IC-F0060-1 – Issue14.0
This certificate may only be reproduced in its entirety and without any change, schedule included. Page 1 of 3
[1] TYPE EXAMINATION CERTIFICATE

[2] Equipment or Protective System intended for use
in Potentially Explosive Atmospheres
Directive 2014/34/EU
[3] Type Examination Certificate Number: DEMKO 11 ATEX 150191X Rev. 4
[4] Product: Industrial Ethernet Switch, Series IE-SW-VL16, IE-SW-VL16T, IE-SW-PL16M, IE-SW-PL16MT, IE-SW-
PL18M and IE-SW-PL18MT
[5] Manufacturer: Weidmüller Interface GmbH & Co KG
[6] Address: Klingenbergstraße 16, 32758 Detmold, Germany
[7] This equipment and any acceptable variation thereto is specified in the schedule to this certificate and the documents therein referred to.
[8] UL International Demko A/S certifies that this product has been found to comply with the Essential Health and Safety Requirements relating to
the design and construction of products intended for use in potentially explosive atmospheres given in Annex II to Directive 2014/34/EU of the
European Parliament and of the Council, dated 26 February 2014.
The examination and test results are recorded in confidential report no.
4788359770
[9] Compliance with the Essential Health and Safety Requirements has been assured by compliance with:
EN 60079-0:2012+A11:2013 EN 60079-15:2010
except in respect of those requirements listed at item 18 of the Schedule.
[10] If the sign "X" is placed after the certificate number, it indicates that the product is subject to the Specific Conditions of Use specified in the
schedule to this certificate.
[11] This Type examination certificate relates only to the design of the specified product, and not to specific items of product subsequently
manufactured.
[12] The marking of the product shall include the following:
 II 3 G Ex nA nC IIC T4 Gc
Certification Manager
Jan-
Erik Storgaard
This is to certify that the sample(s) of the
Product described herein (“Certified Product”) has been investigated
and found in compliance with the Standard(s) indicated on this Certificate, in accordance with the ATEX
Product
Certification Program Requirem
ents. This certificate and test results obtained apply only to the product
sample(s) submitted by the
Manufacturer. UL did not select the sample(s) or determine whether the sample(s)
provided were representative of other manufactured
product. UL has not established Follow-Up Service or other
surveillance of the
product. The Manufacturer is solely and fully responsible for conformity of all product to all
applicable Standards, specifications, requirements or Directives. The test results may not be used, in
whole or in
part, in any other document without UL’s prior written approval.
Date of issue:
2011-04-27
Re-issued: 2018-05-07
Certification Body
UL International Demko A/S, Borupvang 5A, 2750 Ballerup, Denmark
Tel. [phone],
[e-mail], www.ul.com