Document of Conformity

SCHEDULE

EU-TYPE EXAMINATION CERTIFICATE Sira 05ATEX1287X

Issue 5

This certificate and its schedules may only be

reproduced in its entirety and without change

CSA Group Netherlands B.V.

Utrechseweg 310,

6812 AR, Arnhem Netherlands

DQD 544.11 Rev 2018-04-20 Page 2 of 5

13 DESCRIPTION OF EQUIPMENT

The type KSG, KSGDS and KCG ranges of cable glands are intended for use with any cable type where

sealing and retention is required by gripping the outer sheath (this includes armoured/screened/braided

cables, the armour/screen/braid being clamped inside the terminating equipment). Construction

materials are brass, mild steel, stainless steel or aluminium alloy. Glands are available in a single or

double seal configuration and utilise either silicone or neoprene seals. The single seal configuration is

available with alternative compression nuts, which will accept either male, female or flexible conduit. All

the gland types have an IP66 and IP68 (50 meters 7 days) rating.

Glands are available in the size range 12 to 100 mm with ISO metric entry threads of M12 to M100

respectively. Alternative thread sizes and forms ISO metric, NPT, NPSM, BSPT, BSPP, PG and ET are

available.

Variation 1 - This variation introduced the following changes:

i. To allow the batch number shown in the actual product marking to be removed.

ii. The recognition of a number of minor, dimensional design changes.

Variation 2 - This variation introduced the following changes:

i. The KSG, KSGDS and KCG Range of Cable Glands to be marked IP68; this indicates that they have

been tested at a depth up to 25 m for a duration of 30 mins when fitted into either threaded

entries or ‘Ex e’ enclosures that have plain hole entries with 0.5 mm clearances.

ii. The extension of the upper ambient service temperature limit to +85°C for cable glands that

orporate neoprene seals (60° IRHD).

iii. The use of Nitrile Butyle Rubber (NBR) O-ring interface seals with the KSG, KSGDS and KCG

Range of Cable Glands fitted with neoprene sealing rings.

iv. lusion of a new size, 16/M16 in all types, cable gland that has either neoprene or silicone sealing

rings.

v. The modification of the mid cap component.

vi. The introduction of minor drawing changes.

Variation 3 - This variation introduced the following changes:

i. Following appropriate re-assessment to demonstrate compliance with the requirements of the

EN 60079 series of standards, the documents originally listed in section 9, EN 50014:1997

(amendments 1 and 2), EN 50018:2000, EN 50019:2000 and EN 50281-1-1:1998, were replaced

by those currently listed, the markings in section 12 were updated accordingly.

Variation 4 - This variation introduced the following change:

i. The UK manufacturing site was removed from the certificate.