Brochure/Catalogue
Article 137 of the European Community Formation Treaty 
set out the minimum standards in order to improve workers’ 
health and safety, this can also be put at risk by explosive 
atmospheres. An explosive atmosphere is a mixture of 
air and ammable gasses, vapours, mists or dust under 
atmospheric conditions where, following successful ignition, 
the burning process will propagate throughout the whole 
unburned mixture.
The directive 1999/92/EC was transferred into national law. 
Compliance with the minimum standards contained in this 
directive does not guarantee that all relevant national laws 
are met. It is possible for local regulators to introduce more 
stringent requirements.
The employer is required, according to the directive 
1999/92/EC, to take measures to ensure the health and 
safety of the employees. One measure is the division of 
the area into zones where explosive atmospheres could be 
present.
Unless the risk analysis conducted by the employer indicates 
otherwise, all areas where an explosive atmosphere may 
be present must be equipped with devices and protective 
systems that meet the relevant category of the ATEX 
directive 2014/34/EU.
In particular in these zones the following categories of 
equipment should be used, as long as they are suitable for 
use with gases, vapours, mists or dusts:
•  In Zone 0 or Zone 20: category 1 devices
•  In Zone 1 or Zone 21: category 1 or category 2 devices
•   In Zone 2 or Zone 22: category 1, category 2 or  
category 3 devices
Zoning according to the directive 1999/92/EC
Explosion risk areas are classied into zones according to 
likelihood of explosive atmospheres occurring and their 
persistence.
Zone 0
An area which has a potentially explosive atmosphere that is 
a mixture of air and ammable gases, vapours or mists. 
The mixture is either permanently present or frequently 
present over long periods of time.
Zone 1
An area in which during normal operations a potentially 
explosive atmosphere of air and ammable gases, 
vapours or mists can occasionally form.
Zone 2
An area for which during normal operations there is at 
most only a short-term occurrence of a potentially explosive 
atmosphere of mixtures of air and ammables gases, 
vapours or mists.
Zone 20
An area where a potentially explosive atmosphere is present 
in the form of a ammable dust cloud in the air. This cloud 
is either permanently present or frequently present over long 
periods of time.
Zone 21
An area where, during normal operations, a potentially 
explosive atmosphere in the form of a ammable dust 
cloud in the air can occasionally form.
Zone 22
An area where, during normal operations, a potentially 
explosive atmosphere in the form of a ammable dust 
cloud in the air is not normally present or only present for a 
short time.
For the risk assessment and as well as the zoning concept 
described above, Ex devices themselves can be considered 
in an alternative process which uses the equipment 
protection level (EPL). These protective levels determine the 
internal ignition risk of a device where the sort of applied 
protection does not play a role.
Directive 1999/92/EC
Directive 1999/92/EC
W
W.2
Technical appendix
2712630000










