User Documentation

ManualsBrandsWeidmueller ManualsAutomation & SoftwarePNP-32-MOD-TCP

-59-

No.PF※※-OMP0002-H

Troubleshooting

If an operation failure of the product occurs, please confirm the cause of the failure from the following table.

If a cause applicable to the failure cannot be identified and normal operation can be recovered by

replacement with a new product, this indicates that the product itself was faulty.

Problems with the product may be due to the operating environment (installation etc). Please consult SMC.

●Cross-reference for troubleshooting

Fault

Possible cause

Countermeasures

Display

No display.

Incorrect wiring.

Correct the wiring.

[Hi]/[Lo] is displayed

in turn.

Peak (Bottom) value display

function has been selected.

Refer to Peak/Bottom value display (page 54) and

turn off the function.

The display is

unstable.

Foreign matter in the

sensor.

Install a filter or mist separator on the IN side if there

is a risk of foreign matter entering the product.

If there is foreign matter on the mesh, remove it

completely, taking care not to damage the product.

The piping is connected in

the wrong direction.

Mount the product so that the flow direction is the

same as the arrow indicated on the side of the body

or the product label.

Pulsation in the flow.

It is possible that pulsation is generated due to the

fluctuation of the supply pressure or the

characteristics of the compressor or pump used as

the pressure source.

Change to a pressure source with less fluctuation or

install a tank which reduces the pressure fluctuation.

Air leakage.

Correct the piping.

Incorrect display.