User Documentation
Communications
1435710000/01/05.13 101
Change password
◊ This changes the password.
◊ It is only available by pressing the <MODE> key (programming key).
◊ If the programming key is not pressed, there will be no response.
◊ To change the password, an authorisation level (PA0) should be defined, but only ‘0’ is supported.
• Command from master; Control code 18H
68H A0 A1 A2 A3 A4 A5 68H 18H 0CH
⇒
continue
Transmission address Control code
⇒
Continue
DI0 DI1 DI2 DI3 PA P0 P1 P2
⇒
continue
34 3F 33 37
(Add 33H to 01 0C 00
04)
(Only ”0” is supported.)
Designate
authorisation
level (33H fix)
Designate the
present password
(P2: 33H fix)
⇒
continue
PAn P0n P1n P2n CS 16H
Authorisation
level for
password to
change (33H fix)
New password
(P2n: 33H fix)
• Response from slave (normal)
68H A0 A1 A2 A3 A4 A5 68H 18H 04H
⇒
continue
Transmission address
⇒
continue
PAn P0n P1n P2n CS 16H
Authorisation
level for changed
password (33H
fix)
Changed
password
(P2n: 33H fix)