Brochure/Catalogue

Introduction
3 Locate the exact family of modules and the
quantity you require
Example:
• H2016 System Quantity: 1 unit (by card)
or
• I2016 System Quantity: 1 unit (by card)
Take the notes into account (if there are any)
The portfolio includes:
Passive digital input/output interfaces
(H System)
H20: Universal interface for pin to pin 20 pole ribbon
cable (see chapter D)
H2008: Passive input/output 8-channel digital interface
H2012: Passive input/output 12-channel digital interface
H2016: Passive input/output 16-channel digital interface
H40: Universal interface for pin to pin 40 pole ribbon
cable (see chapter D)
Passive digital input/output interfaces for high
voltage (R System)
R1208: Passive input/output 8-channel digital interface
(for high voltage)
R2416: Passive input/output 16-channel digital interface
(for high voltage)
R3632: Passive input/output 32-channel digital interface
(for high voltage)
Passive analogue output/input interfaces
(S System)
A15: Universal interface for pin to pin SUB-D 15 male
poles (see catalogue D)
A25: Universal interface for pin to pin SUB-D 25 male
poles (see catalogue D)
A37: Universal interface for pin to pin SUB-D 37 male
poles (see catalogue D)
A1504: Passive input/output 4-channel analogue
interface
A2508: Passive input/output 8-channel analogue
interface
A3716: Passive input/output 16-channel analogue
interface
A1504M: Passive input/output 4-channel analogue
interface (specic)
A2508P: Passive input/output 8-channel analogue
interface (specic)
A2509M: Passive input/output 8+1-channel analogue
interface (specic)
Relay insulated digital output/input interfaces
O2008: 8-channel insulated digital output interface
positive switching
O2008N: 8-channel insulated digital output interface
negative switching
O2012: 12-channel insulated digital output interface
positive switching
O2016: 16-channel insulated digital output interface
positive switching
O2016N: 16-channel insulated digital output interface
negative switching
I2016: 16-channel insulated digital input interface
4 Note the page number that is shown in the top part
of the column
Example:
• H2016 System -> See page A.35
or
• I2016 System -> See page A.61
5 Once the module family is chosen (step 3 - eg H2016), go
to the page identied in step 4 and locate that family in
the new table on that page.
6 Choose the interface according to your application needs
ie. 1, 2 or 3 wires, screw or tension clamp connection,
with fuse, LED, switch, etc.
7 Go to the specications page where you can check all the
details of the interface.
Note: The interfaces are intended to be used inside an
IP20 enclosure at least.
A
A.112690170000
Universal solutions for PLC input/ output cards