Brochure/Catalogue
RS F – Interface for ribbon cable in accordance
with IEC60603-13/ DIN41651
Passive interfaces for transmitting signals from a plug-in
at cable connector, based on IEC60603-13 / DIN41651,
to a tension clamp or screw connection.
Connection between both connectors is 1 to 1 and the
range includes male connectors with between 10 and
64-poles.
RS SD – Interface for connector SUB-D in accordance
with IEC60807-2/ DIN41652
Passive interfaces for transmitting signals from a plug-in
SUB-D connector based on IEC60807-2 / DIN41652, to a
tension clamp connection or screw connection.
Thanks to the metal casing of the SUB-D these connectors
are ideal for transmitting analogue signals or for connection
with shielded cables.
Connection between both connectors is 1 to 1 and the
range includes male and female connectors with between
9 and 50-poles.
Sub-d High density 15,26,44 and 62 poles also avaliable in
screw connection.
Introduction
Passive interfaces for general applications
Due to the need for cost reductions in the construction of
electric cabinets, our interfaces for general applications offer
an alternative to end-to-end wiring concepts. Their main
function is as an adapter to enable a functional and safe
operation between standard plug-in connectors connected
to any controller or PLC, and printed circuit terminals
connected to application sensors/activators.
Weidmüller‘s universal interfaces for applications have the
following individual features:
• Extruded prole for inserting the PCB
• End plates for tting on the mounting rail
• Clip-on feet for locking on standardised mounting rails
TS 32 and TS 35
• Printed circuit board where the following elements can
be identied:
- Plug-in connectors
- Weidmüller terminals for screw or tension clamp
connection
- Markings
The plug-in connectors used for interconnection can be
divided into the following groups:
• Ribbon cable connector in accordance with
IEC60603-13/DIN41651 (RSF)
• Miniature SUB-D plug-in connectors acc. to
IEC60807-2/DIN41652
• RJ45 connectors for data lines
• Plug-in ELCO connectors for applications in high-demand
industrial areas.
Pre-assembled cables with the corresponding plug-in
connector systems are used in the connection between the
controller and the interface. These pre-assembled cables
allow maximum savings for the user, as they achieve a cost
reduction in the materials, due to fewer individual cables,
conductors and cable ducting.
Advantages of the interface units:
• Space savings thanks to the 2 and 3 oor interface
terminals.
• Conventional end-to-end wiring is only needed on one
side, therefore assembly and start-up times are reduced,
• Greater safety, preventing wiring errors
• Simplied setup and documentation
D
D.2 2690170000
Passive interfaces for general applications