User Documentation

131273570000/00/02.11
4 Loading Material
4.1.2 Inserting a Media Strip into the Print Mechanics
Fig. 8 Material feed path
1. Unroll a longer material strip of approx. 50 cm. Guide the media strip to the print mechanics as shown in figure 8.
2. Turn lever (1) counterclockwise and lever (6) clockwise to lift both printheads.
3. Move guides (4,5) apart with the knob (3) until the media can pass between them.
4. Guide media strip through the print mechanics as shown in figure 9 to the upper print roller (2) and place the strip
between the guides (4,5).
5. Move guides against the edges of the material by turning the knob (3).
6. Fix the media by closing the upper printhead.
7. Turn the media roll against the feed direction to tighten the media.
8. Close the lower printhead.
5
4
6
3
2
1
Fig. 9 Inserting a media strip into the print mechanics