User Documentation

Coupler settings | Saving or restoring module parameters in the coupler
18 2112220000/06/01.2021u-remote web server manual
6.2 Saving or restoring module parameters in
the coupler
You can save the parameters of the connected modules in
the coupler or restore them to the default values.
▶ Click Module parameters.
If no modules are connected to the coupler, the
button is inactive.
Saving module parameters or restoring default values
▶ To save the currently set module parameters, click Save
module parameters.
Previously saved module parameters are overwritten.
The saved module parameters are sent to the modules again
when the coupler is restarted.
▶ To restore all module parameters to their default values,
click Restore default values.
Previously saved module parameters are deleted.
Subsequent changes to the module parameters are possible,
but will be lost again when the coupler is restarted.
6.3 Restarting the web server (Reset)
With a reset, you can undo all the changes that have been
made since the last time that the web server was started.
After a reset, the coupler is restarted.
All data which is not protected against power fail-
ure is reset.
▶ Open the coupler component view.
▶ Click Reset and then Yes.
Restarting web server and coupler
The coupler as well as the web server are restarted.