Brochure/Catalogue
Lightning and surge protection in 6 mm overall width for
measurement and control circuits including isolation/
measuring function
The VARITECTOR SSC combined surge protection, a direct PE contact
function, separation of signal paths and operational status indication in
one module. It is suitable for C&I applications.
The disconnect lever in the terminal guarantees that the measurement/
control circuit can be quickly and precisely switched off to test the signal
path. Using a test plug (PS 2.3 mm), the measuring instrument can
be easily inserted into the integrated test socket on Torx
®
/Slot headed
screws. The shield can be attached onto the additional lower level of
the VSSC 6AN which then leads directly to the PE potential on the
mounting rail. Permanent shielding can be implemented easily using
the EMC set. Weidmüller’s SNAPMARK device marker can be snapped
onto a terminal so that the equipment identication can be easily read
regardless of the installation position. The VSSC 6AN features all the
advantages found in the VARITECTOR SSC product line: a thin 6.2 mm
width, quick PE contact to rail (with up to 20 kA discharge capacity),
simple colour coding for quick identication, large-surface versatile
markers, and the new Torx
®
/slot headed screw.
All VARITECTOR products comply with the latest IEC 61643-21
requirement for a new overstress mode and with categories D1, C3, C2
and C1 according to IEC 61643-22.
VARITECTOR SSC 6AN
VARITECTOR SSC 6AN
Lightning and surge protection in terminal block design
Convenient
Connection convenience is assured by a
clamping rage of 0.5 mm² to 6 mm² with
a Torx
®
/slot headed screw and a 0.8 Nm
tightening torque.
Space-saving
A terminal of just 6.2 mm for two binary signals
or one analogue signals. Terminals can be tted
side by side.
B
B.64 2028840000
Lightning and surge protection
for control and instrumentation signals