Document of Conformity

KEMA ~

(13)

SCHEDULE

(14)

to EC-Type Examination Certificate KEMA 98ATEX1684 U

Installation instructions

Issue No. 2

The Feed Through Terminal Blocks are suitabie for use in enclosures in atmospheres with

flammable gases and combustible dust. For flammable gases these enclosures must satisfy the

requirements according to EN 60079-0 and EN 60079-7. For combustible dust these enclosures

must satisfy the requirements according to EN 50281-1-1.

In combination with other terminal block series and sizes and if other accessories are used the

applicable creepage distances and clearances shall be met.

Regarding the use of end plates, partitions and end brackets the instructions of the manufacturer

must be followed.

If conductors with sm aller cross sections as the rated cross seetion are used, the belanging lower

current has to be laid down in the EC-Type Examination Certificate of the complete equipment.

The Feed Through Terminal Blocks may be used, based on the self-heating when used at the

above mentioned rated current and at ambient temperatures of -50°C to +40 °C at the mounting

position in electrical apparatus, e.g. junction and connection boxes, for temperature class T6. When

the Feed Through Terminal Blocks are used in electrical apparatus of temperature classes T1 up to

T5, the highest temperature of the insulating material shall not exceed the maximum value of the

operating temperature range.

Unused terminals shall be tightened.

Routine test

The routine dielectric strength tests according to EN 60079-7, clause 7.2 or using the method as

laid down in document no. A_10_07 shall be conducted.

(16) Report

KEMA No. 2112447.

(17) Special conditions for safe use

None.

(18) Essential Health and Safety Requirements

Covered by the standards listed at (9).

(19) Test documentation

As Iisted in Test Report No. 2112447.

MEAN-P-Ex61 v2.1

Page 3/3