Document of Conformity

(13)

(14)

KEMA

:l(

SCHEDULE

to EC-Type Examination Certificate KEMA01ATEX2106 U

Mounting instructions

The Feed Through Terminal Blocks and Protective Conductor Terminal Blocks are

suitable for apptication in enclosures in atmospheres with f1ammable gases and

combustible dust. For f1ammable gases these enclosures must satisfy the requirements

according to EN 50014 and EN 50019. For combustible dust these enclosures must

satisfy the requirements according to EN 50281-1-1.

In combination with ether terminal block series and sizes and If ether accessories are

used the applicable creepage distances and clearances shall be met.

Regarding the use of end plates, partitions and end brackets the instructions cf the

manufacturer must be followed.

If smaller cross sections than the rated cross section are used, the belonging lower

current has to be laid down in the EC·Type Examination Certificate of the complete

apparatus.

The Feed Through Terminal Blocks may be used, based on the self-heaUng when used

at the above mentioned rated current and at ambient temperatures of 40°C to +40 °C at

the mounting position in electrical apparatus, e.g. junction and connection boxes, for

temperature classes T6 and T5. When the Terminal Blocks are used in electrical

apparatus of temperature c1asses T1 up to T4, the highest temperature of the insulating

material shall not exceed the maximum vaJue of the operating temperature range.

Routinetest

According to EN 50019, Clause 7.1.b in combination with Clause 6.1, a dielectric

strength test has to be carried out.

(16) Report

KEMA No. 2012240.

(17) Special conditions for safe use

None.

(18) Essential Health and Safety Requirements

Essential Health and Safety Requirements not covered by the standards Iisted

(9)

Clause Sub'ect

1.0.5 Markinc

1.0.6 b Instructions

These Essential Health and Safety Requirements are examined and positively judged.

The results are laid down in the report listed at (16)

Issue1

09.02.2005

Page 3/4