Beipackinformation Operating instructions Notice d’utilisation 1 7 13 Analogsignaltrenner WAVEANALOG OLP aus der WAVESERIES Analog signal isolators WAVEANALOG OLP from the WAVESERIES Séparateur analogique de signal WAVEANALOG OLP de la gamme WAVESERIES R.T.Nr. 4288740000/03.
Analog signal isolators WAVEANALOG OLP from the WAVESERIES Type Cat. No. Screw connection WAS5 CCC OLP 8543720000 Tension clamp connection WAZ5 CCC OLP 8543730000 Please read these instructions before using the product and retain for future information.
1. General instructions Warning! The analogue signal isolators of the WAVEANALOG may only be installed by qualified personnel. Be sure not to connect the unit to power supply before appropriate installation. Do not select ranges during operation, because live parts are exposed during this process. Be sure to observe the national regulations for installation and selection of cables.
3. Configuration 3.1 Equipment A screwdriver with a width of 2.5 mm is required to adjust the unit and to connect the wires to the terminals. 2 3.2 Opening the unit Disconnect the plugs. Disengage the top part of the housing by carefully pressing the latches on both sides (1). Pull out the top part of the housing and the electronics section until they lock (2). 1 1 3.3 Application 24Vdc 230Vac ~ ~ 230Vac 24Vdc 1 2 3 0...10V WAVEANALOG OLP 8543720000/8543730000 7 8 9 4 ...
4. Mounting Die The analogue signal isolators are mounted on standard TS 35 rails. 5. Electrical connection Terminal assignments 1 2 3 4 5 6 7 8 9 10 11 12 Current input 0/4... 20mA Voltage input 0...10V Input 0V-reference potential Not assigned Not assigned Not assigned Current loop 4…20 mA + Not assigned Current loop 4…20 mA Not assigned Not assigned Not assigned Wire cross-section max. 2.5 mm2 Multi-wire conncection max.
Dimensions in mm 73,4 111,4 38 92,4 90 17,5 6.
. Accessories Connection markers Designation WS 10/5 Multicard for plotter marking WS 10/5 Neutral Cat. No. 1635010000 1060860000 8. Notes on CE marking The WAS5/WAZ5 PRO Freq. analog signal isolators are marked CE in accordance with the EU directives 89/336/EEC "Electromagnetic Compatibility" detailing the Harmonized European Standards (EN). The declarations of conformity are held, according the above mentioned EU directive, article 10, for the authorizing body by: Weidmüller Interface GmbH & Co.
