Quick Start Guide v1.7 Owner manual

ManualsBrandsWeidmuller ManualsHardwareWI-I/O 9-L-R: Wireless I/O Receiver

Quick Start Guide

WI-I/O 9-L-R Wireless I/O

Receiver Unit

WI-I/O 9-L-R QuickStart v1.7

Summary of content (8 pages)

PAGE 1
Quick Start Guide WI-I/O 9-L-R Wireless I/O Receiver Unit WI-I/O 9-L-R QuickStart v1.
PAGE 2
WI-I/O 9-L Receiver Unit Quick Start Guide This document is the WI-I/O 9-L-R Wireless I/O Receiver Unit Quick Start Guide and contains the following sections: Section Read this section if you want to … Basic steps for using your unit Learn the basic steps for installing and using your unit. Factory default configuration Understand how the transmitter sends information to the receiver. Unit components Understand the different parts of your unit.
PAGE 3
WI-I/O 9-L Receiver Unit Quick Start Guide Your WI-I/O 9-L-R receiver unit has the following components and terminal connections: Earth Wire Lug underneath Unit - DO 3 - DO 2 - DO 1 NOT USED NOT USED - POWER SUPPLY + - AO DO 2 DC LOAD DO 1 LOAD Max. 30VDC 500mA + For inductive load, use surge diodes + LOAD SYSTEM OK COMMS FAIL COMMON + 24V + - ANALOG OUTPUT Max.
PAGE 4
WI-I/O 9-L Receiver Unit Quick Start Guide front panel contains the following components: SMA antenna connector at top of unit RS232 configuration port RSSI push-button The LEDs on the front panel indicate the unit status: LED Status Indicates None No power supply. OK LED Green Current status of the unit OK. OK LED Red Fault condition detected in unit. RX Led Flashes Receiving Message. CF Led ON Module Communication Failure Output is active. PG LED on Configuration Cable Connected.
PAGE 5
WI-I/O 9-L Receiver Unit Quick Start Guide WI-I/O 9-L Receiver Unit Guide v1.
PAGE 6
WI-I/O 9-L Receiver Unit Quick Start Guide You must reset the receiver unit to factory defaults before linking the transmitter and receiver units. To reset the default factory configuration: 1. Press and hold the RSSI push button. 2. Power on the WI-I/O 9-L-R receiver. 3. The WI-I/O 9-L-R receiver flashes all LEDs at medium flash (i.e. 1.6 Hz). NOTE: If the LEDs do not flash, you must repeat steps 1 and 2 until the LEDs flash before continuing. 4. Release the RSSI push button within 5 seconds. 5.
PAGE 7
WI-I/O 9-L Receiver Unit Quick Start Guide Thank you for selecting the WI-I/O 9-L receiver for your telemetry needs. We trust it will give you many years of valuable service. To ensure your WI-I/O 9-L receiver enjoys a long life, double-check ALL your connections with the user’s manual before powering on the unit. WARNING: Incorrect termination of supply wires may cause internal damage and will void warranty. Exposure to RF energy is an important safety consideration.
PAGE 8
WI-I/O 9-L Receiver Unit Quick Start Guide Document information Quick Start Guide WI-I/O 9-L-R Wireless I/O Receiver Unit Weidmuller, Inc. contact details Address > 821 Southlake Blvd., Richmond, VA 23236 Telephone > (800) 849-9343 Fax > (804) 897-4135 Email > info@weidmuller.com Website > www.wireless.weidmuller.com Limited lifetime warranty, disclaimer and limitation of remedies Weidmuller Inc.