User Manual

WI-I/O 9-L-x Installation Guide
WI-I/O 9-L-x v1.6 Page 34 of 39

You can configure your network using:
 Default factory configuration – that lets you easily setup your network as a simple
send/receive; or
 User-defined customized configuration – that lets you set specific information
about your network and allows communication with other Weidmuller Inc. WI-I/O 9-x
series devices.
For more information on setting a user-defined customised configuration, see the User
Manual.
For more information on setting the factory default configuration, refer to the Quick Start
Guide included with your module.
The following table details the factory default configuration:
Signals sent over radio
WI-I/O 9-L-T(Transmitter) Sends WI-I/O 9-L-R (Receiver)
Digital Input 1

Digital Output 1
Digital Input 2

Digital Output 2
Analog Setpoint

Digital Output 3
Analog input (4-20 mA)

Analog output
Other signals
WI-I/O 9-L-T(Transmitter) WI-I/O 9-L-R (Receiver)
Thermocouple Input (Not used)
Setpoint Output (Local indication)
Communication Failure
(Comes on if no messages from WI-I/O 9-L-
T)
System OK (On if system OK) System OK
(On if system OK)