Manual

WI-I/O 9-x Wireless Module User Manual v2.16
WI-I/O-EX-1-S-x Serial Module
Page 42
4.3.2 Program Operation
Start the software by either clicking
on the start bar and navigating to the
Configuration menu or by running
WISeries.exe in the directory selected
in the setup stage.
The Initial screen will appear. The
configuration is performed for a
complete system. The necessary
configuration stages are:
 select system name and system
address
 select individual units and unit
addresses
 configure I/O mappings for each unit
 configure user options for each unit
 load the configuration files into each unit.
From the initial screen, you can select an existing project, or start a new project. The name of the
project will create a new directory which will eventually contain th e configuration files for the modules
in this system.
When you have selected the project, a screen
will appear where you may enter the system
address.
If you are editting an existing project, the
system address will already have been entered.
Do not change the system address unless you are
going to re-program all of the modules in the
system.
Password. You have the option of entering a
password to protect the configuration files
against unauthorized changes. When you open a
new project, you will be as ked to enter a
password - if you do not enter any text - that
is, press “ESC” or “Enter”, then password
protection is disabled. If you do enter a
password, then you will need to enter this
password to make changes to the configuration
or download or upload configuration. You only
need to enter the password each time you enter
the project. Without the passowrd, you are able