Manual

WI-I/O 9-x Wireless Module User Manual v2.16
WI-I/O-EX-1-S-x Serial Module
Page 52
Pulse Output Update Time Configuration
The pulse output update time is the
time period over which pulses are
output after a PI update is received.
It should be configured to
correspond to the pulse input
update time for the corresponding
pulse input. This ensures that the
pulse output rate matches as closely
as possible the pulse input rate
which it is reflecting.
For example, if the PI update time is 1 minute, then the PO update time should also be 1 minute. If
the PI update time is changed, then the PO update time at the remote module should be also changed.
The PO will still operate if the time is not changed, however pulses may be output faster or slower than
the input pulses.
To configure the pulse output time, select “Pulse Outputs” on the left-hand menu and select the “Pulsed
Output Time” page - double-click the pulse output and enter the new time.
Pulse Output Enable
The PO’s for the -2 and -4
modules are also DO1-4.
To use as pulse outputs,
you need to enable them as
pulse outputs.
To enable pulse outputs,
select “Pulse Outputs” on
the left-hand menu and
select the “Enable/Disable”
page - double-click the
pulse output to enable.
Compiling a System
When you have finished configuring the modules, you should compile the system. The compile
function scans the configuration and reports any detected errors. To compile the system, select
“Compile System” from the “Utilities” menu. Select the “Compile” button. The system will compile -
the display will show if there are any compile errors or warnings.