Manual

WI-I/O 9-x Wireless Module User Manual v2.16
WI-I/O-EX-1-S-x Serial Module
Page 66
Connect the module (ensure the RS485 port is disconnected first) to the PC using the same serial cable
used for configuration.
The diagnostics menu is accessed by removing the blue “plug” from the front of the module and setting
all switches to ‘0’ or “Open”, and holding down the red button for approximately 5 seconds, until the
RX LED lights continuously. One of the following menus will be displayed on the terminal :
WI-I/O 9-1
a) Ins
b) Tones
c) Comms
d) DO1
e) DO2
f) DO3
g) DO4
h) AO1
i) AO2
j) Switch
k) Signal
>
WI-I/O 9-2
a) Digital Ins
b) Analog Ins
c) Tones
d) Comms
e) DO1
f) Switch
g) Signal
>
WI-I/O 9-3
a) Ins
b) Tones
c) Comms
d) DO1
e) DO2
f) DO3
g) DO4
h) DO5
i) DO6
j) DO7
k) DO8
l) AO1
m) AO2
n) AO3
o) AO4
p) AO5
q) AO6
r) AO7
s) AO8
t) Switch
u) Signal
>
WI-I/O 9-4
a) D Ins
b) A Ins
c) Tones
d) Comms
e) DO1
f) DO2
g) DO3
h) DO4
i) DIO1
j) DIO2
k) DIO3
l) DIO4
m) DIO5
n) DIO6
o) DIO7
p) DIO8
q) DIO9
r) DIO10
s) DIO11
t) DIO12
u) Signal
>
Choose an item from the menu by entering the letter before that item. For example, to select the
"Signal" function from the WI-I/O-EX-1-S-11 Menu, enter :- k
During the diagnostics session, if you press Enter or Space while the menu is displayed, the module
will restart in normal operating mode. To re-enter diagnostics mode, hold the red button for 5 seconds
etc.
After the diagnostics session is over, force the module to restart, then select “Stop Terminal”, then
“Close”.
Inputs
This option provides a dynamic display of the status of all of the inputs in the WI-I/O 9-x, both internal
and external.