Instruction Manual

Chapter Five Specifications
Page 51
Signal detect / RSSI -120 to -60 dBm
Expected line-of-sight range USA / Canada
Australia / NZ
Range based on 19200
baud. At 57600 baud,
expected range is 60%,
at 115200 baud,
expected range is 30%.
20+ miles
20+ km
depending on local conditions
Range may be extended using
intermediate modules as
repeaters
Antenna Connector Female SMA coaxial
Serial Ports
RS232 Port DB9 female DCE RTS/CTS/DTR/DCD hardware
signals provided
RS485 Port 2 pin terminal block Max distance 4000’ / 1.2 km
Data rate (bit/sec) -
configurable
1200, 2400, 4800, 9600,
14400, 19200, 38400,
57600, 76800, 115200
Byte format 7 or 8 data bits Stop/start/parity bits configurable
System Parameters
Operating modes Transparent mode
Controlled mode
Broadcast system
Addressed communications with
acknowledged
System address Configurable 8 bit
User Configuration Hayes commands from host
device.
Or via on-board DIP switches
Diagnostics
LED’s OK, DCD,
Radio and Serial RX/TX
Low signal receive led
CTS/RTS indication
RSSI measurement in
dBm
BER test