Owner manual

TOUCHPAD ELECTRONIC LEVER

Quick Installation Guide

1. Check Dimensions 2. Install Latch & Strike

Tools Needed

Phillips Head Screwdriver

Ruler

Hex Wrench

In Box

Pencil 4 AA Batteries

Phillips Head Screwdriver

If: 2

⁄4˝ (70 mm)

If: 2

⁄8˝ (53 mm)

Ruler

Angle

faces jamb

Jamb

2A 2B

(x4)

PAGE 1
Quick Installation Guide TOUCHPAD ELECTRONIC LEVER Tools Needed In Box Hex Wrench Ruler Phillips Head Screwdriver Pencil 1. Check Dimensions 4 AA Batteries 2.
PAGE 2
3. Install Exterior Keypad & Interior Mounting Plate D F (x2) Phillips Head Screwdriver E E E D F ! 4. Install the Half Round Spindle 5.
PAGE 3
5. Install Interior Assembly (cont.) I (x2) Phillips Head Screwdriver 5B 5C I 6.
PAGE 4
6D Install Exterior Lever 6. Mout the Levers & Cylinder (cont.) 6C Install Interior Lever J NOTE: Cylinder will not sit back fully until 6E ! 6E Secure Cylinder & Exterior Lever 1 2 90° 3 90° 4 5 L (x2) 7.
PAGE 5
7A NOTE: Complete 7C & 7D AFTER programming ) x4 AA ( 7D 7C M 7B Programming Program Button Lock Button Keypad User Codes User 1 User 2 1 2 3 1 56 34 12 2 3 56 56 34 78 12 90 34 78 12 90 56 78 90 34 12 78 90 x2 Press Program Button User 3: 1 x3 Enter 4–8 Digit Code 2 Press Lock Button 3 Press Program Button (x2) User 4: 1 x4 2 Enter 4–8 Digit Code Press Lock Button 3 Customizable Features On 1 LED Status LED blinks every 5 seconds.