User guide

EXTERIOR

INTERIOR

8.Automatic-BoltDirectionDetermination(DoorHanding).

IMPORTANT:DONOTSKIPTHEFOLLOWINGSTEP.

LOCKWILLNOTBEABLETOOPERATEPROPERLY!

● In the steps below, the SmartCode mechanism automatically

determines the “door handing” and sets the proper direction for mo-

tor to rotate. The system will drive the bolt several times during this

process.

a.Pressandholdthe“LOCK”buttonontheexteriorkeypad,whilefully

insertingthebatterypackintotheinteriorassembly(thetabonthepack

mustfaceout-seeillustration).Holddownlockbuttonuntilyouhear2

beeps(about20seconds).Itisveryimportantthatthisprocessis

allowedtonishproperly.

7.Installbatteriesintobatterypack.

AlkalineBatteryWARNING:Donotdisposeofinre,recharge,

putinbackwards,disassemble,mixwithusedorotherbatterytypes.May

explodeorleakandcausepersonalinjury.

a. Install4newAAAlkalinebatteries.

Installthenewbatteriesasindicatedinillustration.Makesure

batterieslieatinholder.For best performance,

rechargeable batteries are not recommended.

Note: Do not install battery pack into unit until you start step 8.

LOCK

Button

Tab

Battery Pack

LED

Continued