Technical data

OWNERS MANUAL FOR WEISS DAC202 D/A CONVERTER

Page

Date: 03/10

Pressing the knob when the display shows the main menu

activates the selection of the “Options Menu” as shown here.

Pressing the knob again enters the “Options Menu”. Rotating

the knob instead of pressing it navigates to the input source

select as shown here. Pressing the knob again allows selecting

the input source. If any parameter is shown with the two dots in

the upper left and lower left corners, then rotating the knob can

change that parameter. To confirm a setting the knob has to be

pressed again. The two dots vanish and the parameter is set to

the value indicated. This picture shows the two dots in the input

selection menu.

Selectable input sources are:

1. FireWire

2. AES (XLR)

3. SPDIF (RCA)

4. SPDIF (TOSLINK) –note: up to 48kHz sampling rate only!

This picture shows the AES/EBU input on XLR selected. There

isn’t any valid signal at the AES/EBU input thus it shows

“unlocked”.

The “Options Menu” explained:

Upon entering the Options Menus the display as shown here

appears. The highlighted item is the one which can be changed

/ executed by pressing the knob. E.g. if the knob is pressed with

the display as shown, the Options Menu is exited.

Here is a rundown of all entries in the Options Menu:

1.) Abs. Phase: “+” or “-“. A “+” means the signal is not

inverted when passing through the DAC202, A “-“ means the

signal is inverted.

2.) Upsample Filt.: upsample filter type “A” or “B”. Later

software versions may allow to select “C”, “D” etc. “A” uses a

steeper filter than “B”. Also see the Technical Data section.

3.) Sync Source: (these instructions assume that neither

dual wire nor insert modes are selected, for dual wire and/or