Datasheet

Version 001
8
IdeaWerk Plus User Manual
3.3 Print from USB flash disk notes
3.3.1 The maximum memory of the USB flash drive model recognized by
this IdeaWerk Plus is 32GB.
3.3.2 This IdeaWerk Plus can recognize up to 58 model files in the USB
flash drive, and it is recommended to store no more than 20 model files.
3.3.3 If the USB flash drive has been inserted but the IdeaWerk Plus can
not find the device, it is possible that the the USB flash drive is inserted
before the IdeaWerk Plus is powered on, or it contains too many model
files. You can pull it out and re-insert it.
If the computer can recognize the USB flash drive, but the IdeaWerk Plus
can’t, you can format it in the default mode of the operating system.
3.3.4 If the USB flash drive is formatted or a new USB flash drive is used
for printing from USB flash disk, be sure to create a new folder named
“3DMODEL” in the USB flash drive directory where offline print files are
stored. If the folder is created in any other folder or the offline print files
are stored elsewhere, the IdeaWerk Plus can not recognize.
3.3.5 The file name can be in Chinese or English. The length is not more
than four Chinese characters or eight English letters, and if exceeded, the
excessive part will be shown as “~ 1”. For example: “High-Tech
Product.WTK” will be shown as “High-Tech~1.WTK” and
“PRINTMODEL.WTK” will be shown as “PRINTM ~ 1.WTK”.
3.3.6 The file name shall contain no special character.
3.3.7 During the printing, the platform temperature can not be set below
the room temperature, otherwise the extruder can not print properly.
3.3.8 ABS material has relatively high shrinkage, and the recommended
ambient temperature is 20 °C-32 °C, because the low ambient
temperature will affect the effect of model printing.