Datasheet

Version 001
13
IdeaWerk Plus User Manual
4.3.6.4 Hold the middle mouse button, and you can move the overall
model display frame.
4.3.6.5 Click the model with the right mouse button, and the following
menu pops out. Select “Land” and the model will descend to the center of
the platform. Select “Reset” to restore the original state of the model. You
can also select “Remove”to uninstall the model.
4.3.7 Model view display
4.3.7.1 After the model is selected, click the menu icon “View”. The
following figure is the model view display in terms of “Reset”.
4.3.7.2 Click the menu icon “Top”, the model will be displayed at the
overlooking angle, as follows.
4.3.7.3 Click the menu icon “Side”, the model will be displayed at the right
viewing angle, as follows.
4.3.7.4 Click the menu icon “Front”, and the model will be displayed as
follows.
4.3.8 Print parameter settings
4.3.8.1 Click the icon “ GCode” and the setting dialog pops out.
4.3.8.2 The dialog to generate GCode is divided into three parts, the
column “1” is to set model parameters, the column “2” is to set IdeaWerk
Plus parameters and the column “3” is to generate GCODE.