Datasheet

Version 001
16
IdeaWerk Plus User Manual
click “Setting”. This value is height of the generated printing file which can
also be set before IdeaWerk Plus connection.
4.3.8.16 Set the nozzle temperature: directly input the temperature in the
dialog box and click “Setting”. For PLA material, the recommended
temperature is 220-230 °C and for ABS material, the recommended
temperature is 230-240 °C.
4.3.8.17 Set the platform temperature: directly input the temperature in
the dialog box and click “Setting”. For PLA material, the recommended
temperature is 40 °C or below and for ABS material, the recommended
temperature is 80-100 °C according to the size of the model.
Notice: the platform temperature cannot be set lower than the
ambient temperature.
4.3.8.18 After the above parameters are set, click “Generate GCode”.
4.3.8.19 During GCODE generation, in case of improper parameter
settings found, click “Cancel GCode”, as shown below.
4.3.8.20 After GCODE is generated, the interface pops out as shown below,
and click “OK”.
4.3.9 Control the printer
4.3.9.1 Click the icon of IdeaWerk Plus control, and the control interface
pops out.
4.3.9.2 IdeaWerk Plus control includes three parts: movement control“1”,
temperature control “2” and Z-axis height setting “3”, as shown below.