Datasheet

Version 001
18
IdeaWerk Plus User Manual
feed or return the material. If you click “Forward/Reverse “, the following
prompt box will pop out.
4.3.9.9 Notice: difference between the temperature setting here
and “Print parameter settings” in 4.3.8: The temperature setting here is
to set the temperature of the IdeaWerk Plus when software is connected
to the IdeaWerk Plus. If the temperature is set at 220 °C as GCODE file is
generated but the temperature before printing is set at 230 °C, the
printing is carried out at 230 °C. It is the same with the platform
temperature setting. The temperature setting in 4.3.9.16 and 4.3.9.17 is to
set the temperature as GCODE file is generated, which can be set before
software is connected to the IdeaWerk Plus.
4.3.9.10 In the part of Z-axis height setting, click “Roughly”, and Z-axis
platform will automatically descend to the lowest point and then rise
close the nozzle nozzles. At this time, according to the distance between
the platform and the nozzle, click “▼” after “Accurately” to select the step
length of single Z-axis movement. If “0.5” is selected for debugging of this
IdeaWerk Plus, which is equal to clicking “Accurately”, Z-axis moves
0.5mm upwards. The less the distance between the platform and the
nozzle, the smaller the step length. If the platform touches the nozzle,
choose a negative for the movement downwards, as shown below.
4.3.9.11 The precisely moving height of Z-axis platform, you can just put a
card between the platform and the nozzle, as shown below.
4.3.9.12 Click “Meter Z”, and the IdeaWerk Plus automatically starts
measuring. You can see the increase of the figure in the dialog after “Z:”.
After the measuring is complete, click “Setting” to complete the
measuring of Z-axis height, and following printing will be carried out in
terms of this height.
4.3.9.13 After a period of use or height of the platform needs to be
fine-tuned, you can directly modify the figure in the dialog after “Z:”, and
click “Setting”.
4.3.10 Model movement
4.3.10.1 Sometimes you need to move the model before printing. After
the model is selected, click the menu icon of model movement on the left,
and the interface pops out.
Notice: only after the model is selected, the menu icon of model
movement can appear.